the world. It features an embedded web server, security
protection, and LED indicators for switch-working status.
work like IO Server. This system can be integrated with
industrial field applications.
Provides +12VDC from DC Jack or
Terminal Blocks
INTRODUCTION
The EDG-421 series data gateways are designed to adopt your industrial serial devices to the Internet instantly. It delivers simple, reliable and cost-effective network connectivity for multiple serial devices. It address the need to connect individual RS-232 or RS-422/485 devices, such as PLCs, meters, sensors, to an IP-based Ethernet LAN. It makes your application software to access serial devices anywhere on a local area network or the Internet.
The EDG-421 provides 7 GPIOs (General Purpose Input Output) pins to provide extra digital I/O control signals over Internet as well.
A reset input port is designed to reset the whole hardware of the EDG-421 . This feature is used to reset the EDG-421 if it is hang.
The EDG-421 is easy to install or remotely through a variety IP addressing methods (UDP, IP, TCP, ICMP, HTTP, DHCP, ARP-Ping). It is ideal for applications requiring either serial ports or Digital I/O environments and network device management.
SPECIFICATIONS
LAN Port:
Ethernet: 10/100 Mbps, RJ45 connector
Protocols: UDP, IP, TCP, ICMP, HTTP, DHCP, ARP-Ping
Serial Interface
The Serial interface provides a DB9 RS-232 connector and a RS-422/485 terminal block connector. You can only use either RS-232 or RS-422/485 (but not both at the same time).
The key benefits are:
RS-232 Connector: DB9 male
RS-422/485 Connector: 4-pin terminal block, 2/4-wire
configured via DIP switch
Interface: 3 modes are selectable: 4-wire RS-422 (TXD+/-,
RxD+/-). 2-wire RS-485 (TxD+/-, RxD+/-). 2-wire RS-485 (Data+/-, Data+/-)
Parity: None, Even, Odd
Data bits: 7,8
Speed: 300bps to 115.2Kbps
Terminator: 120 OHM, can be Enabled/Disabled by DIP switch
15KV ESD protection for all signals
Provides wall and rack mounting holes
Digital I/O pins
7 Digital I/O pins for control applications. They are designed in terminal block connectors
Reset Input
The reset input connector accepts the active signal from outside. If the signal was forced to low, then the EDG-421 will reset all its hardware.
Power Requirements
+12VDC DC from Jack or from Terminal Block Connectors
Environmental:
Operating Temp.: 0 to 558C (32 to 1318F)
Storage Temp: -20 to 858C (-4 to 1858F)
Operating Humidity: 5 to 95% RH
Important Technical Information:
RS-232/485/422/DIO to Ethernet Data Gateway |
PCI Multi-I/O Expansion Card with 1 Parallel Port & 2 serial from $39.98
