Cat5 DVI-D Extender (Model: DASL-101) (49 feet) 15 Meter Range via Cat5 or Cat6 cable Transmitter(DAS-101T) Receiver(DAS-DR) 1. Extend DVI-D signal over Cat5e/6(UTP 24AWG) cable. 2. Video signal type: DVI-D single link 3. Max. Resolution/Distance: 1280x1024(HDTV 1080I, 720P)/10m, 1024x768/15m, 480P/20m 4. DVI-D to RJ45 transmitter (DAS-101T) at PC or DVI output device to transmit the DVI-D signal to Cat5e/6 cable 5. RJ45 to DVI-D receiver (DAS-DR) at DVI display to receive the DVI-D signal from Cat5e/6 cable 6. No external power is required. Installation: 1. Please turn off the DVI-D output device and DVI-D displays. 2. Plug in the DVI-D to RJ45 Transmitter (DAS-101T) to DVI-D display. Turn on the display. When orange LED lights, turn off the monitor. Then disconnect. 3. Plug in the DAS-101T to DVI out port of DVI-D output device. Use Cat5e/6 cable (1:1 pin-out), plug in one end to RJ45 port of DAS-101T and plug in another end to RJ-45 port of RJ-45 to DVI-D receiver (DAS-DR) and connect DAS-DR to DVI display. 4. Turn on the DVI display and DVI output device. 5. The orange LED of DAS-101T indicates powered and the green LED indicates an active DVI-D video signal. Remarks: 1. Please read this manual carefully before installing the extender. 2. Please use high quality Cat5e/6 cables for optimum operation. Cat6 cable is better than Cat5e cable. If there is Electric Magnetic Interference, use FTP or SSTP cable to improve. 3. One year limited warranty. Trademarks: All the companies, brand names and product names referred to this manual are the trademarks or registered trademarks belonging to their respective companies.