FWU2-IDE02B is a
FireWire 800 (IEEE 1394b) & USB 2.0 Combo to IDE (ATA/ATAPI) bridgeboard
featuring the Oxford OXUF-922L FireWire 800 (IEEE 1394b) & USB 2.0 Combo to IDE
(ATA/ATAPI) Bridge Controller and Ti's new IEEE 1394b 800Mbps PHY (TSB81BA3) .
FWU2-IDE02B is ideally suited for tailgate interface applications for removable-media drives CD-ROM, CD-R, CD-RW, DVD-ROM, DVD-RAM, tape drive, and hard disk drive. It allows IDE drives (Master and Slave) to be connected to FireWire 800 (IEEE 1394b) serial bus in a plug-and-play fashion. Both ATA and ATAPI devices are supported using the same firmware.
FWU2-IDE02B allows users to easily hot-swap IDE drive without interrupting the current operation. FWU2-IDE02B provides the perfect solution for data backup and transfering of data between computers using IDE (ATA/ATAPI) devices.
USB 2.0 & FireWire
800 (1394b) to IDE (ATA/ATAPI) Bridge Board:
- DC Power Connector:
with mini 4-pin Floppy Disk Drive power connector
- USB 2.0 and FireWire
800 (1394b) arbitration: Auto-Switch by detecting USB bus power.
- IDE (ATA/ATAPI)
Interface: Male IDC 2X20 Connector
- Both ATA and ATAPI
devices are supported using the same firmware.
- Complies with T13's
ATA/ATAPI-7 Draft Specification:
- PIO Mode 0 ~ 4
- DMA Mode 0 ~ 2
- Ultra DMA Mode 0 ~ 6
- Supports 48-bit LBA
for large hard drives (>128GB).
- USB 2.0 Interface:
One mini B-5pin USB connector
- USB Bus Transfer
Rate: High Speed (480 Mbit) And Full Speed (12 Mbit)
- USB Bus Power: Self
Powered Mode Operation
- Number of 1394b
ports: External X 2 (Bilingual-9pin)
- 1394b PHY: Ti
- 1394 Bus Transfer
Rate: 100/200/400/800 Mbps
- Physical Dimensions:
3.33" x 2.00" (8.45cm x 5.00cm)
Fit to most standard SCSI enclosure.
(SCSI I 50pin Connector Form Factor)
To turn your SCSI enclosure into FireWire & USB 2.0 ComBo enclose
- Designed with the
SCSI 1 50pin connector form factor in mind, FWU2-IDE02B is ideal for your SCSI
users can upgrade their SCSI enclosure to FireWire800 (1394b) & USB 2.0
- SCSI Enclosure
vendors selling or integrating ATA/ATAPI devices are provided with an immediate
and no-risk solutions to add FireWire800 (IEEE 1394b) & USB 2.0 ComBo
interface to their product lines.
End users can replace
the slow & expensive SCSI device with affordable & fast
FWU2-IDE02B. It also provides peripheral vendors a unique opportunity to
continue the advantage of ATA/ATAPI while presenting FWU2-IDE02B into the
rapidly expanding FireWire800 (IEEE 1394b) & USB 2.0 ComBo markets.
- FWU2-IDE02B Bridge
- Ultra DMA100 Cable 18"
inch for TWO devices(master/slave)
- Y-Shape DC Power
Cable (Red, Black, Black, Yellow)
- Installation Guide.(online download only)
|Important Technical Information:
PLEASE NOTE: OXFORD 922 does not support Master/Slave Configuration on USB, it can only do so for Firewire 800 Connections!