IDE TO SATA or SATA to IDE CONVERTER BOX works with Devices and MotherBoards.
Break the standards barrier with this bi-directional Parallel and Serial ATA adapter. Have a SATA hard drive but only IDE headers? Have an IDE hard drive but only SATA headers? This is your easy fix! Plug this in the back of your IDE hard drive or straight into your motherboard\'s IDE header. Then plug your SATA cable in the other end! Power it with the convenient power adapter cables and you\'re done! Order yours today!
General Features: IDE to SATA 1.0 SATA 1.0 to IDE Conversion Type switch LED Power indicator Easy install & No driver needed Automatic SATA 1.5 Gbps speed negotiation ATA / ATAPI PIO mode 0 to 4 ATA / ATAPI Ultra DMA transfer rates: 16.7, 25, 33, 48, 66, 100, 133, 150 MB/s. ATA / ATAPI LBA48 addressing mode associated with 2-byte sector count Supports SATA hot-plug Ultra low power consumption Works for AC & DC couple between transmitter and receiver Provides specified OOB signal detection and transmission Supports Spread Spectrum Clocking to reduce EMI (Electro- Magnetic Interference) Supports Partial/Slumber power management Provides adjustable TX signal amplitude and pre-emphasis level Supports Slave drives Adapters included to power unit from 4-pin Molex M/F, SATA, 4-pin floppy connectors Package Includes: Parallel and Serial ATA Bi-Directional Converter SATA cable SATA power and 4-pin female Molex power connector adapter 4-pin Molex male/female and 4-pin floppy power connector adapter Driver CD 8 93049 00047 2 MM-IDE<=>SATA-01-BC01