USB-COM
PRO Specifications & Features
- Serial connector : one DB9 male
connector and one 5-pin Terminal Block for easy wiring
- Power Supply: works in USB self
power mode (5V, 500mA), no external power supply is needed
- Adds high speed RS-232 / 422 /
485 port via USB connection
- 384 byte receive buffer
- 128 byte transmit buffer for high
speed data throughput
- Requires no IRQ, DMA, I/O port
- Serial transmission speed up to
921.6 Kbps
- Suitable for 4-wire RS-422/485
and 2-wire RS-485 applications
- Auto receive/transmit control for
2-wire RS-485 half-duplex operation
- Tx ,Rx Termination resistors installed
on-board and easy enable/disable via software utility or console port
- Tx ,Rx BIASing resistors installed
on-board and easy enable/disable via software utility or console port
- Easy operation mode change via
software utility or console port
- RS-232
data signals : DCD, RxD, TxD, DTR, GND, DSR, RTS, CTS, RI
- RS-422
data signals : Tx-, Tx+, Rx+, Rx-, GND, RTS-, RTS+, CTS+, CTS-
- RS-485
data signals : Tx-, Tx+, Rx+, Rx-(4 wire), and data-, data+(2 wire)
- Monitor LEDs of TxD, RxD of each
port indicating port status
- Monitor LEDs of mode indicating
serial port operation mode
- Virtual COM port drivers available
for Windows 2000/XP/2003/Vista
- Metal case