Overview

IDE-SATA01

Parallel ATA to Serial ATA Host mode Bridge Board (1.5Gbps) featuring Marvell 88SA8040 Serial ATA Controller   

PRODUCT OVERVIEW

DE-SATA01 is a Parallel ATA to Serial ATA Host mode Bridge Board featuring Marvell 88SA8040 Serial ATA bridge Controller.

IDE-SATA01 is ideally suited for tailgate interface applications for removable-media drives CD-ROM, CD-R, CD-RW, DVD-ROM, DVD-RAM, tape drive, and hard disk drive. 

Both ATA and ATAPI devices are supported using the same firmware.
It allows SATA drives (Master or Slave) to be connected to ATA host controller. IDE-SATA01 provides the perfect solution for legacy ATA host controller to attach new SATA devices.

PRODUCT HIGHLIGHTS 

 Parallel ATA to Serial ATA Bridge Board:

Serial ATA:
- Compliant with Serial ATA 1.0
- 48-bit sector addressing 
Serial ATA Connector: 
- Signal + Power Female Type Connector 
Parallel ATA:
- Ultra ATA/133 Parallel Interface
- 48-bit sector addressing 
        - Jumper for selecting Mater and Slave 
Parallel ATA Connector:
- Male IDC 2X20 pin Connector 
Transfer Rate:
- Supports PIO and DMA modes
- Supports bus master DMA at 1.5Gbps burst rate 
DC Power Connector:
- Mini 4-pin floppy type power connector 
Physical Dimensions:
- 3.97" x 1.00" (10.09cm x 2.54cm)
- Direct Connect Vertical type 

OPERATING SYSTEMS SUPPORT

Windows 98 
Windows NT 4.0 
Windows 2000 
Windows Me 
Windows XP 
Linux 
KIT CONTENTS

IDE-SATA01 
Big 4pin to floppy drive like Mini 4-pin DC Power Cable (Red, Black, & Yellow) 
USER'S MANUAL 
1-WARRANTY CARD