eSATA and USB 2.0 Bridge Board Serial ATA Hard Drive Support

Ultra Fast USB 2.0 SATA Conversion Bridge Board Using JMicron and NEC Chip

• Use this Small PCB to convert your existing Enclosure to eSATA and USB 2.0 Output Device.
• Standard SCSI Mount Bracket fits most enclosures

CGS-1U2Sis ideally suited for tailgate interface applications for One SATA or SATA II devices. It allows SATA drive to be connected to USB 2.0 serial bus in a plug-and-play fashion.
It Also Provides ONE eSATA External Port for Connecting to SATA Host Adapters
CGS-1U2S provides the perfect solution for data backup and transferring of data between computers using SATA drives.

USB 2.0 to SATA Bridge Board:

• DC Power Connector: with mini 4-pin Floppy Disk Drive power connector
• Serial ATA port: One Signal Plug Type (7pin) Connector Latching Type
• Serial ATA Bus Transfer Rate: 1.5 Gbps up to 3.0 Gbps Using SATA II Drives
• Support hot-plug & hot-swap feature of Serial ATA to USB.
• USB 2.0 Interface: One USB Mini B-Type connector
• SATA Interface: One eSATA External type "I" connector
• USB Bus Transfer Rate: High Speed (480 Mbit) And Full Speed (12 Mbit)
• USB Bus Power: Self Powered Mode Operation
• Supports 48-bit addressing for large hard drives (>128GB). Tested with Drives up to 500GB
• Complies with Gen1i and Gen1m of Serial ATA II Electronical Specification 1.0
• Power indicator LED and SATA Access LED
• Physical Dimensions: 2.97" x 1.34" (7.54cm x 3.40cm)
• SCSI Centronics Connector Form Factor
• (Fit to most standard SCSI enclosure)

• Windows and Mac
• Windows 98SE, ME
• Windows 2000, XP
• MacOS 9.1 or higher
• Driver Requirements No driver installation for Windows ME, 2000, XP and Mac OS
• Driver available for Window 98 SE
• CGS-1U2S bridge board.
• A-to-B type USB 2.0 Cable (1.0m length).
• SATA 7pin to SATA 7pin cable for SATA HDD.
• Y-Shape (one IDE big 4pin male to one floppy drive like mini 4pin and one IDE big 4pin female)
• DC Power Cable (Red, Black, Black, Yellow)
• Overview and User\'s Guide